helmet hardening

oney

New Hunter
Hello. I have made my helmet fiberglassed it and filler. I know have the shape and all indents sanded out. I know want the filler to be rock hard. I used a easy sanding filler so it's not rock hard if it is banged it will leave a mark. Any idear what I can do next to make it rock hard?? I have not painted it yet it has a filler finish so far. Thanks :)
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top