New source for chest monitor(?)

I guess...

but it was just an idea.. might be good for custom fetts? who know? I just threw the link out there see if anyone would find it useful... hence the question mark in the topic..
 
This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

MAULFETT
Jabba throne for My Boba Fett throne
Replies
0
Views
361
MAULFETT
MAULFETT
Rook 3
Q: Best filament for helmet/armor printing?
Replies
0
Views
899
Rook 3
Rook 3
Badjudget
Coating for my Helmet?
Replies
1
Views
1,324
Rook 3
Rook 3
MAULFETT
Rancor Head for the Boba Fett throne
Replies
0
Views
975
MAULFETT
MAULFETT
jhfagan
Make your own basic helmet stands for under $10.
Replies
1
Views
1,816
dreadpyrat
dreadpyrat

Similar threads

MAULFETT
Jabba throne for My Boba Fett throne
Replies
0
Views
361
MAULFETT
MAULFETT
Rook 3
Q: Best filament for helmet/armor printing?
Replies
0
Views
899
Rook 3
Rook 3
Badjudget
Coating for my Helmet?
Replies
1
Views
1,324
Rook 3
Rook 3
MAULFETT
Rancor Head for the Boba Fett throne
Replies
0
Views
975
MAULFETT
MAULFETT
jhfagan
Make your own basic helmet stands for under $10.
Replies
1
Views
1,816
dreadpyrat
dreadpyrat
Back
Top