teraxis
Hunter
Okay this build is probably going to take awhile but I wanted to get started that way I can get advice as I go. I am starting with an Asok budget Boba helmet. The trick to this is this helmet started as someone else's custom mando build that fell off a shelf. So since the dent was gone my thought to do it up as an ESB display piece went out the window. On top of the dent being filled the helmet has a few cracks, luckily the vast majority of them are in the cold cast layer so the base is fairly solid.
here is the helmet as I received it.
1. front view- bodo work had been started here. Dent was actually cut out of the helmet.
2.back view- no major problems on the back itself
3. left side - as you can see this side has some heavy damage and there are chunks of the cold cast layer missing.
4.Right Side- this is after a little sanding has been done. Note there is a chunk missing from the range finder area.
5. Inside view - this is the one crack that has me worried.
6. This is the goal of this project
here is the helmet as I received it.
1. front view- bodo work had been started here. Dent was actually cut out of the helmet.
2.back view- no major problems on the back itself
3. left side - as you can see this side has some heavy damage and there are chunks of the cold cast layer missing.
4.Right Side- this is after a little sanding has been done. Note there is a chunk missing from the range finder area.
5. Inside view - this is the one crack that has me worried.
6. This is the goal of this project
Last edited by a moderator: