electrical assistance needed...(with pics)

TX-7365

Hunter
Hey there,Im working on my right gauntlet & I trying to wire up a simple white LED in the front.
I have the LED,the resistors,the battery? & the toggle switch for the gauntlet.
Now can any one draw me up a diagram on how this going together.

Heres what I got. Guy at the store helped,but was alittle unsure it it would work.
Also not sure if I should use a 9V or something else for the power source.
thanks in advance.

LED
image_zpsad1d9ac7.gif


Resistors
image_zps83efab97.gif


Toggle switch
image_zps65e5b419.gif


- - - Updated - - -

I did also use a resistor calc & & this is what it told me would work.
 
Brother, Buy a mini book light, or similar small flashlight that will fit in there. I'll be doing the same thing. Haven't modded that yet, though. Something like this: Amazon.com: Ultrathin Book Light - Silver (Untrathin) (9781935009146): Mighty Bright: Books

I assume you're mildly savvy with soldering... Crack this open (Or something similar), extend the wires if need be to put that toggle switch in between the positive or negative wire to complete/disrupt the circuit.
 
What dident I think of that!!! I have a few led pen lights.
Check me out overthinking something so simple, what what I'd do without you.
thanks brotha
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top