New guy

CNCFabricators

New Hunter
Hello everyone I'm new on here. Finally found the time to make a profile on here. I'm owner of a CNC fabrication shop in Arcadia Louisiana. I mainly make 3D college logos out of steel but I will /can make just about anything. I'm a cad draftsman and CNC programmer for over 20 years. Let me know if I can help any of you with your builds.


Sent from my iPhone
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top