ASOK Cold Cast ESB

Geeza

New Hunter
Hey Guys, about to start my first helmet project. Copped the ASOK CC ALU lid, the cast looks amazing.

IMG_4170.jpg

Just a quick question, will JB Weld be sufficient for mounting the screws for the visor and ears?

Feel free to give me any advice!!!
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top