skeg man
Hunter
G'day all!
So while all my parts are gradually turning up. I decided to work on a Hasbro ee-3 conversion. Being in Australia, there is no real chance of importing any kits. So I had to work with what I can get a hold of.
I pretty much only kept the pistol body and scrapped the rest. The barrel is made from PVC pressure pipe (48mm OD) and the T mold is two plastruct right angles (1/4 maybe?) glued together. The overall look is good enough. But maybe a tad over sized?
The stock is built up from laminated sintra (fourex, foamex).I think it came out ok.. once again, maybe a touch too long.
Anyways.. any input would be great. I'll be sure to post up my armor and so forth once I start.
Cheers for reading
Sent from my PadFone
So while all my parts are gradually turning up. I decided to work on a Hasbro ee-3 conversion. Being in Australia, there is no real chance of importing any kits. So I had to work with what I can get a hold of.
I pretty much only kept the pistol body and scrapped the rest. The barrel is made from PVC pressure pipe (48mm OD) and the T mold is two plastruct right angles (1/4 maybe?) glued together. The overall look is good enough. But maybe a tad over sized?
The stock is built up from laminated sintra (fourex, foamex).I think it came out ok.. once again, maybe a touch too long.
Anyways.. any input would be great. I'll be sure to post up my armor and so forth once I start.
Cheers for reading
Sent from my PadFone