Needed help with a jet pack harness

I been working on my resin jet pack and getting to the point where I need to build a hardness. I need some do's and don't before I start working on it. I want to get it right the first time.

Can anyone help me.

Thanks,
Buddhafett
 
hey buddha, try tk409's website, he has a simple inexpensive way to make a harness, i am at that point as well, and am going to try his method. hope this helps.

www.tk409.com
 
Last edited by a moderator:
Ask and ye shall receive :D
http://www.TK409.com/images/fett/harness/1.jpg
http://www.TK409.com/images/fett/harness/2.jpg
http://www.TK409.com/images/fett/harness/3.jpg
http://www.TK409.com/images/fett/harness/4.jpg
http://www.TK409.com/images/fett/harness/5.jpg
http://www.TK409.com/images/fett/harness/6.jpg
http://www.TK409.com/images/fett/harness/7.jpg

diagram.gif
 
Last edited by a moderator:
Hey TK...can you show a pic of your backplate. So we can see the slots. I have a similar harness...but the pack rides way low.
 
Last edited by a moderator:
Let me know if you want some accurate black webbing for the straps. It's 100% accurate.
 
Last edited by a moderator:
Arent the straps off-white? I'm not sure but in the reference pictures of MoM the straps holding the back on are sorta white colored.
 
Last edited by a moderator:
The straps that extend out of the backplate are off-white, but the waist strap and the straps that go around the arms and connect at the top and bottom of the metal frame are black.
 
Last edited by a moderator:
This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top