Progress

image.jpg 3d printed jetpack harness
 
image.jpgimage.jpgimage.jpgimage.jpgimage.jpgToday I went to my first Con. My costume still not finished but I went anyway. 18,000.00 people in attendance lots of them took pics of the good old BOba. Thanks Dented Helmet and all of the members!
 
image.jpgimage.jpgThe MOW beacon does not come with the holes so I had to carefully Dremel them. Next I made a hole in the middle using a drill and then put zinc-plated nipple to add electronics later.
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top