Veteran prop builder new to the Fett props scene

BobaFettsDayOff

New Hunter
Hi new forum!

New to the site, just saying hi mostly. I'm a veteran prop maker who's taken an interest in acquiring/building a Fett suit as a hobby. Here's some photos of things I've made in the past, mostly weapons and leather working. Here mostly to learn about and get tips on my own Fett project: going to start with a basic helmet (which I need for a photo project in January), then upgrade and build off that til I have a complete suit. If anyone has a suggestion on where I should start, I'd be delighted to hear it!

Gunsmithing and Bladesmithing:

A couple custom revolvers I built on Ruger single action platforms:
IMG_4011.jpg

IMG_4087.jpg


A knife I made when I learned blacksmithing:
IMG_3789.jpg


A cheap stainless kukri machete that I aged down and did decorative file work on, pictured with an ancient cleaver that I did nothing to whatsoever:
IMG_2832.jpg


Leatherworking:
Custom tanker style shoulder holster rig for the custom blackhawk:
P1140989-2_zpsc659a96b.jpg


General Stuff:
Post Apocalyptic car:
IMG_0781.jpg


Post apocalyptic charcoal grill:
IMG_1912.jpg

IMG_1910.jpg
 
Last edited by a moderator:
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top