Darth Malgus WIP

BSD

New Hunter
Hello everyone.. I started to make a Darth Malgus build.. I have the mask part done. I am just not 3d printing the shin armor. Soon will come the knee then forearm and then to the reast. Here is what I have so far.

For faster updates and to see other things I am working on.. Like my page https://www.facebook.com/pages/Ruthlessfx/549594578385708

1001435_664645450213953_409415748_n.jpg


1229985_664645453547286_695809873_n.jpg


971764_658723317472833_1645783304_n.jpg


525709_658723320806166_2035779512_n.jpg
 
Yeh that's excellent,jules is a friend of mine I've seen this in person it's epic,he's also a member here darth serbaus...
 
Been a while since I posted my work on my Malgus.. Been busy working on other stuff.. Here is what I have done now.. I have the leg, forearm, and hand printed.. Still some small details to clean up but it is moving right along!

1382330_691365934208571_2136898873_n.jpg


1382084_692694934075671_219349048_n.jpg


1405028_696608500350981_630820212_o.jpg


1273333_696608477017650_494980847_o.jpg


886723_696608463684318_1312523512_o.jpg
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top