Key slot bubbles

Mjolner

Hunter
I recently got a helmet with resin bubbles (blobs) in the key slot by the mq1 board. Any guidance on how to remove these without damaging the bucket?
Thanks!
 
i used a dremel rotary tool with a small engraving cutter bit.. its got a little ball on the end .. just find one that fits between the slots.. :Dare you any good at the game operation?:D
 
correct ... just a regular dremel ... and good luck.. just remember if it gets bad you can always do what Fett4Real suggested and cut them out and put in a MQ1 casting..
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top