Need help trimming/sanding my new armor

KaiMartin

Hunter
Hey guys I'm in need of some help. I was wondering... How do i properly trim and sand armor? What accessories should i be using if im using a dremel. Or what grits of sand paper should i be using. This is armor from RKD. How deep should i be sanding? Thanks IMG_1327.jpgIMG_1328.jpgIMG_1326.jpg

IMG_1325.jpg
 
Last edited by a moderator:
I use the dremel to get most of the extra plastic off and the sand by hand to get it smooth. Just be careful with the dremel. You don't want to remove to much. Sandpaper wise start with a heavier grit to a finer one.i used an 80 to get it where I want it then 120 to smooth the edges. I didn't sand anything else on my knees. Hope this helps some.
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top