OU-R2 Beneath The Dent.. Asok Budget CC

thank you.. that means a lot ... with out your hard work (and the work of others on this site) i could not have made this far .. that is for sure
 
i got paint down on the mandibles today:)

asokwipesb37.jpgasokwipesb38.jpg

- - - Updated - - -

still have the kill stripes, weathering, and finer details to go

asokwipesb39.jpgasokwipesb40.jpg

asokwipesb37.jpg


asokwipesb38.jpg


asokwipesb39.jpg


asokwipesb40.jpg
 
Last edited by a moderator:
Awesome!! I have an Asok Budget cc i'm going to start on this weekend. I downloaded the RAF ESB stencil but they are a little small. Do you have a link for a better stencil for this helmet?
 
no sorry BFQ .. i never printed the stencils .. i used them as a reference.. but as far as placement of everything .. i did it free hand.. i bet if you contact Raf he would help you with the sizing of the stencils..i think it is a matter of what percentage to print them out ..

here is a link with info on the back panels for the Asok CC

http://www.thedentedhelmet.com/f23/asok-cold-cast-helmet-template-question-46669/

Hope this helps some.. let me know if you have other questions and i'll try help you the best i can

Justin
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top