How do you apply Smooth Cast to the outside a cardboard helmet?

Jgbeerman

New Hunter
I was wondering how people put a layer of smooth cast on the outside of the cardboard helmets? Can it just be painted on or is their a better technique? I understand slush casting for the inside, just not sure for the outside.

Thanks
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top