Thermal Detonator Hardware

LemonChord

New Hunter
Hello,

I am just trying to build a (V1?) thermal detonator like the one Princess Leia holds in her hands in Jabba's Palace in episode 6. There are no problems with regard to the outer shell, I've already found a couple of instructions for it. However, there will be problems with the sound and the LED technology as I don't know anything about electronics.


I imagined it to look like this:


Could anyone help me with a step-by-step instruction please? Or maybe with a schematic circuit diagram? It doen't have to be exact. If it comes to the worst the sound may be omitted or the lights may blink in another way.
 
Last edited by a moderator:
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top