Rako Hardeen helmet

lolow

New Hunter
was bored so i tryed to do this in cardboard (that suck by the way ) tell me what you think ???? should i keep going or scrap it until someone do a real pepakura file
34yy2av.jpg




23lkzg8.jpg
 
casted some resin breader things and antenna holder and did 3 coats of resin outside of the helmet and did one today inside......
15mo6z6.jpg
 
this is where i am on it so far ......yesterday did some fiberglass inside to re-enforce it more, and did some bondo , all the pre cleaning is olmost done . its getting closer to the end
still need to start bondo on antenna ...

25fkeh0.jpg


jr8it2.jpg


24fmxio.jpg


2z65zs5.jpg


15vort.jpg


2drrhqe.jpg
 
im getting so close to the end ,i installed the antenna holder ,cut the visor ,just need a little more tlc do be done .. (95%)

test with bearder put in loose

9iwae0.jpg


the helmet so far

4t6iz5.jpg


35n3gx5.jpg


5vypgh.jpg


s2z8t2.jpg
 
where i am with the work on it ................. olmost done = (all the scratch are close to possible to image from the show)

15gr22h.jpg


2ahhc7m.jpg
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top