Inside helmet

Adoo

Jr Hunter
Hi Guys

This has probably been asked a million times but...

My lid needs some padding etc inside to stop it wobbling around and to make it comfy to wear, what suggestions do people have and what is inside your lids.

I have a big head so not much room either.

Thanks
 
I use a helmet band from an old M1 helmet and mounted it on to a hard hat rim that i cut to fit inside the helmet... I like the look of the leather from the M1, and it gives a good adjustable snug fit...
 
I went a little different route lol working electronics exposed to give it a touch of realism. The top pad is just a round chunk of open cell foam sewn into a pocket with velcro to hold it in place. Around the back is some craft foam pieces and part of an interior kit by Marrow Sun
eef9f193.jpg
 
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top