Asok Cold Cast Boba Sticky??

MandoJude

New Hunter
I just received my OUTSTANDING Asok boba fett cold cast helmet and ive been cutting out the ring and t and noticed that it sticks to my jeans. not bad sticky but seems like its still a tad wet. if i hold it long enuf in some spots my print will mark it. is this norm?
please help
newbie here
 
You should wash the helmet with soap and water to remove the release agent that helps take the helmet out of the mold.

The cold cast aluminum finish also just picks up prints ... some guys have been using a clearcoat to seal it as well.
 
Another question about cold cast. Do u still paint it silver for a boba fett paint job or does the cold cast act as the silver And just start from there with grey next?
 
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top