Zam Wannabe

I may need a little help molding the armor, though... joshsurf, could you try to give me a few pointers on that? 'Cause I'm kinda new at this costuming thing.... <insert "oops" face here>
 
I'm in the same boat. I need to figure out how to mould the leather to look right. Luckily I have a friend who has worked extensively with leather in the movie industry and I'm hoping he can guide me through it.
 
I'm kind of working by myself on this project, Sirene, but thanks for your input. Anyone on TDH who can guide me through this? If you can guide me "in forum" then that would be good. thanks, everyone, for your help and input! ;)
 
Last edited by a moderator:
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top