Drilling shoulder studs

BlackCatBone

Active Hunter
How do you guys typically drill the shoulder studs to prepare them to screw down onto the neck plate? Any tips? I'm afraid they'll crack.

Thanks!

BCB
 
I filled my keyboard keys with JB Weld putty. Then I drilled it out a bit and stuck a nut inside. The nut is wedged in there and doesn't move. I have screws comming in from the bottom of the back armor. The screw that goes through the cape is a bit longer to make it easier to put the cape on.
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top