shaping the armor

R

reed

Guest
does anyone have any tips on shaping the armor sections? i'm talking about the chest plates and shoulder pieces.i think the cod piece will be the hardest.i'm making it out of aluminium so any pointers will be much appreciated.
 
Boba = the shape of the chest sections is very rounded. Almost like the were shaped from a 50 gallon barrel.

Jango - much more angular on the ends. (if that makes sense)

Shoulders - it may sound funny but an empty large glass pickle jar works great. Just heat up the shoulders (assuming your using sintra) and mold them around the pickle jar.

PM me if you have any more detailed questions.

Jordan
 
This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top