Bo Katan Bo-Katan Helmet - Pepakura

HD1138

New Hunter
Hello everyone! I would like to show you that I'm working on right now. I'm from Venezuela and I specialize in creating Pepakura models. perhaps some of you have already seen my work in the clonetrooper.net forum.

Some people have asked me for this helmet, so I decided to do it. and what better place than this to receive your comments or criticisms about this helmet.

well, here's the model...

403290_10150738073231038_727896037_12264636_1413818955_n.jpg

427113_10150738077786038_727896037_12264648_760996377_n.jpg


is still a bit raw, but I'll go update their progress in the coming days.
 
Here are some images with the parts you can change for accuracy:

417622_10150753207771038_727896037_12308865_717542376_n.jpg 427287_10150753212421038_727896037_12308875_766401974_n.jpg

Don't get me wrong, I like what you did so far (I wish I could do things like that).
 
Thanks, Rafalfett, for pointing out these details I had overlooked. I have made ​​corrections and I think that the model is ready now.

422236_10150780458246038_727896037_12388435_1943588949_n.jpg


the helmet have a 90% or 95% of accuracy. maybe I have to make a few changes on rangefinder.

427316_10150780463276038_727896037_12388446_2045363720_n.jpg


what do you think?
 
Muy Bien! Very cool. Wish I knew more about pepkura. My friend who I am in the 501st with has talked about trying to a pepakura project.
 
My only criticism is not making the bottom rim of the helmet a perfect oval. Make the bottom a little more egg shaped or even angular. It will make a HUGE difference when its in your hands. The oval bottom makes helmets wonky. Very nice file though.
m2
 
The only thing you need to clean up... on the browline, over the vertical bar of the visor, between the earcaps... the brow should not be a raised brow like Fett. The brow meets the dome and there is a slight ridge where the angle changes but, it is flush. The raised portions starts at the back of the earcaps and goes around the back. I hope that made sense?

If you look at my finished thread and Cruzers thread you can see what I mean. Look VERY closely at the stills and you can somewhat see it but, it's hard to ID but, it's there. I have some images that show it clearly but, I cannot share them as a promise to the source.
 
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top