what thickness sintra should I use

wthrgssr75

Jr Hunter
I found a supplier in my town that sells expanded pvc sheet for $18 for 2mm or $22 for 3mm. Which is the ideal thickness to use for troopable armor?
 
I would have to agree with thaxos.. 3mm will work just fine (have have made a couple sets of armor from 3mm).. with a single 4'x8' sheet you will have more then enough for your armor and possibly a second set of armor as well.. One piece of advice though for the gauntlets and helmet ( if your gonna make them as well) use 1mm as it is easier to get to form for a tighter curve
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top