Need measurements for JP holes in the backplate

OPPI

Active Hunter
Like the topic says.... Exactly where do the square/rectangular holes go for the JP straps??? I guess a measurement from the bottom of the plate would be best as that is where there is a straight surface as opposed to the rounded shoulder part..

thanks for the help all
dan
 
Although someone could certainly figure out the exact size and locations of those holes,
I think it depends more on your harness system as well as the size/weight of your jet pack.

If you base the holes on pre-determined measurements, you might not end up with a
comfy fit. Your harness straps could also end up putting excess strain on your backplate.
 
This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top