Starting FP ESB gauntlet build - Flamethrower question

Roninson

Hunter
I've started working on my gaunts from FP, and noticed that there's resin that sits under the aluminum stalks of the left gaunt flamethrower. I'm not sure if this is structual or if just a part of the mold. I know removing the resin here would make it more screen accurate, but wasnt sure if this was the best solution as its more stable with it left intact.

Has anyone here built up the flamethrower with this in place?

Thanks in advance...

Flamethrower_Detail.jpeg
 
Last edited by a moderator:
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top