Cod piece/Butt plate questions

I'm in the process of cutting out my MB cod piece and I'm not 100% sure where to cut along the bottom and sides. Can anyone point me to some reference pics of say a view of the back and bottom? Also I don't have a Butt plate, any idea where I can find just the butt plate to match the size of MB's cod piece.

Thanks.
 
This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top