Possible helmet material?

Ogunn

Jr Hunter
so i was in walmart looking for a trashcan to make my armor out of and i ran across a wrapping paper holder...it was a great size for me to cut the back plate of the armor out of and i got the belt and codpiece too...but the thing that grabbed my attention about it was the top they had for it...if you see the pics it has a decent shape to it... i was thinking a couple of cuts and a splice together and it would be an alright for a bucket or at least for the dome of a helmet....would def need a heat gun to change the shape a little...idk...maybe someone can use it for something so i thought i would upload a pic...

imag0131v.jpg


Uploaded with ImageShack.us

imag0130.jpg


Uploaded with ImageShack.us

imag0127x.jpg


Uploaded with ImageShack.us

imag0128z.jpg


Uploaded with ImageShack.us
 
Last edited by a moderator:
It could work for sure,
DSC04606.JPG
These are the bukets I used to used on my early helmets , These are actual bukets with paint in them but you can buy them empty for using as bukets/ paint pots what ever , from hard were stores.
I made 6 using these and they worked great , how ever I personally not a fan of doing the dome with the pep files method Ive always gone hard had or horse riding helmet cut in to 4 quaters and reattached in a nore Fett dome shape , it tends to get beter results (my opinion any way)
 
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top