Paint Question

Golgotha

Hunter
Hey,

I have a Jango stye bucket coming and I want to repaint it. Do I sand the helmet down then apply a primer coat, then finishing coats? I was going to use Krylon spray paints for everything. Good idea or bad?

Thanks

Bryan
 
Definatly sand first, then Primer, then top coat.
Krylon should be just fine.
Suggestion though, if you are using chrome spray paint apply several thin coats and allow to dry. If you build up too many coats too fast, the under layers won't cure properly.
You don't want to pick up your nicely painted bucket only to leave finger prints in it. Plus, everytime something touches it, it will leave a mark.
So be patient. Chrome paint needs alot of cure time.
I bought some Chrome duplicolor brand at Wal-Mart and it seems to cure alot faster than Krylon.
Just my experience.
Hope this helps.
Thanks,
Robert E.

Also, if your using the Chrome paint, make sure the helmet is perfectly smooth!
Any imperfections will show.
 
This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top