Hey guys new to this. helmet help please

ok i see the regular helmet link now. but what i mean is the ones at the bottom are ones you have to download. and the regular helmet link you dont have to download. my printer does good with the downloadable ones. but the regular helmet link that you dont have to download my printer prints it to small.
 
ok i see the regular helmet link now. but what i mean is the ones at the bottom are ones you have to download. and the regular helmet link you dont have to download. my printer does good with the downloadable ones. but the regular helmet link that you dont have to download my printer prints it to small.

you can download the first one too... right click "save as".
 
Ive had that happen to me but not knowing your set up , i think CNG 's advisre is the wisest,
but got to resize and clik fit to margin
 
helmet is almost finished, i gotta make the rf and the dent and then its ready to paint. just curious tho. how do you go about making the dent.?


ps i used the same cardboard the ant man used
 
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top