WIP: Getting started with my Boba Armor... Wish me luck

SmuWindu

Jr Hunter
Using the templates I pulled from DungedBeetle's site... Have the Shoulder Bells, Cod Piece, Collar, Belt cut out and placed on cardboard... Will be glassing them this weekend. Hoping for the best and will see how everything comes out once I get some more resin. The lot I had went bad :( Guess that's what happens when you stop doing projects for 3-4 years.

I'll put up pics as I go along.
 
true... Here are some pics of what's been done so far.. Everything is ready for resin, and glass...

collar and shoulder bells.jpg

cod piece front and rear belt.jpg

chest and belly plates.jpg
 
Well thanks to the bad weather and a nice sheet of acrylic that I forgot I had laying around I decided to see if I could make some decent pieces of armor using the templates I already cut out. Here is a shot of all the upper armor minus the Cod piece and center piece.

IMG00046-20110126-2011.jpg
 
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top