Left Gauntlet Flame-Thrower Construction Question

Jedi Bob

Well-Known Hunter
I am about to finish up this piece and wanted to know if the inside of the FT (nozzle) should be painted prior to inserting the 2 nozzles.

I was going to glue the 2 holed attachement in and then when it is all done and painted, just glue in the 2 nozzles.

Sound right?
 
Hey JB, I assembled the nozzels on to the 2 hole support separate to make sure that they where glued the right way. Then I painted the inside of the flamethrower in aluminum and after it was dryed just attached the entire (painted and weathered) nozzel setup to the flamethrower housing. After that I just glued the bottom part of the flamethrower.

I then painted the flamethrower covering the nozzels so that they would not get painted. ;)

I found it easyer to assemble the nozzel setup first.

I hope I was of some help. :)
 
This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top