Slave 1 in 1:48 scale

SerpentKing

New Hunter
Here's a side project I'm working on. The Fine Molds Slave 1 is 1:72. This will be significantly bigger. I've considered a 1:32 version, also . . .

What you're looking at is the upper portion of the underside, where the radar dish attaches. The large notch at the bottom houses the main engine.

1(2).jpg


2.jpg


3.jpg


4.jpg


5(2).jpg


6.jpg


7.jpg


8.jpg


9(2).jpg


10(2).jpg
 
Wow, this looks like its going to be a ton of work, but it will be so so so worth it in the end! Kudos on taking on a project like this, and good luck with it! Can't wait to see the final product!
 
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top