Ok, so the rear is laid out the way I want it, and its got a nice coat of primer, getting rady for rubber.
Ive had a few questiojns as to why I have changed some things.
The main questions are 'Why did you remove your rear piece. The quick answer is, it needed to be a lot flatter in order to not cause problems with people with bigger noggins. The second reason is I felt the over detail, was more episode 123 than 4 5 6. Anotherwords. Too techy. I have revamped the sides to have less detail, and tried to give the whole rear piece a nice feel, that should match the rest of the helmet.
The second question is, 'why arent there more pieces'. The simple answer is, you dont see it flat on, you see it from an angle, as noted in the pictures below. I wanted it to look techy, and full, but not overly so.
Ill need to light sand some of the flat pieces and then spray one more time, and then it goes in rubber, should be able to put a rubber pull, in the helmet this weeknd for photos.