Jawa Ion Blaster

totallyice

Jr Hunter
Here's a few pics of the finished blaster, holster, and power pack
MVC-001S-2.jpg

MVC-002S-2.jpg

MVC-003S-3.jpg

MVC-001S2-1.jpg
 
Check out the step-by-step process here:

http://www.thedentedhelmet.com/show...d-Step-By-Step-Pic-HEAVY!?p=495711#post495711

The power pack was made from a block of wood; sanded and Dremeled with the design. Then d-rings placed on either side and a leather strap. I used the same woodgraining technique that I used on my blaster. The hose is a simple 1/4" car vacuum hose. I used the metalizing technique on the hose. You can check out the woodgraining and metalizing tutorials at the above link.

28-1.jpg

29-1.jpg

30-1.jpg

31.jpg

MVC-002S-2.jpg





You can check out an awesome power pack tutorial here:

http://www.tk1336.com/jawa.html
 
Last edited by a moderator:
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top