Backplate / Jetpack alignment question...

Splat762

Active Hunter
Where exactly does the jetpack sit on the backplate? Does it sit flush with the bottom of the backplate? I know it doesn't lean in with the backplate either, it sits straight up and down yes?
 
On the screen used pack the back of the pack sits close to the back plate, the packs shape allows this, in that it is wedge shaped. The bottom of the pack sits a few inches from the bottom of the armour, with the original harness supporting the pack through the semicircle cut out.

Hope that helps.

Rob.
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top