Michell Engineering Turntable Sweep Arm Wrist Dart Variations

Art Andrews

Community Founder
Community Staff
This was first pointed out to me by Gino and I wanted to share it with you. There are at least two variations of the "wrist dart" that is a part of the Michell Engineering Turntable Sweep Arm. The typical dart (which seems to be much more common) has a short shank and a more squat dart head which the atypical (only know of two of them at the moment) dart has a longer shank and a much longer dart head. Just thought you might want to know!

darts.png
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top