How to install RF lights?

TJDFett

Hunter
So, I am thinking about getting Hyperdyne or mrgr8ness self contained RF lights. The kind with a tilt switch. But how will I get them inside my range finder? Do I need to pry off the clear plastic piece? I have a Boba maker range finder (ROTJ) if that helps. Any advice will help.
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top