FG helmet question

asok

Well-Known Hunter
I just bought a FG helmet. What should I do with the inside? In some places it is smooth and in other places it is not. I don't feel like cuting my skull.
 
Take some rough grit sandpaper (100 or less) and sand the rough areas down, then use higher grits (150-600) until you get it as smooth as you want it. This worked for my helmet. I'd recommend wearing a dust mask and eye protection as FG dust is a very nasty thing to inhale, and you definately don't want to get it in your eyes.
 
I'd have to say Sandpaper as well, even though a dremal is a great tool, it's just that one slip of the dremal & there goes a precious piece cut right down your FG helmet. Just take the time & sand'er down... good luck -
 
This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top