My First Fett "Fettish"

Thread starter Fuzzual
Start date Sep 14, 2009

Fuzzual

Hunter

Sep 14, 2009

Hello all! I have just finished my first step in Fett Armor. The trash can armor direction was definitely the best way for me to go, thanks much to AFettFullofDollars! Your my hero!

I have a question about the collar. It seems in most of the pictures that I have seen, that the inner cut of the collar is round. However, the Wizard Templates have no rounded shapes on the collar. Just wondering what I should do, or if this even makes any sense?

At any rate, I am going to post my progress on this thread, I would appreciate any advice or dare I say criticisms you may have. Thanks so much!

This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.