Scope Mounts: Simple tough question

Stormrider

Well-Known Hunter
Ok, so sidewinders mounts (I think, ive only seen the ones sold on ebay that I think were copies of his) are one sided, as are the ebay ones.

Im not sure if its because of acuracy, or simplicity making the piece.

Before I make the final mold for these, im wondering, is the mold supposed to be two sided, or one sided. IE: the part flat on the backs.

Does anyone have, or has anyone seen the back (in pictures) of the real scope mounts, to know if they are flat, or the same as the front

mounts.jpg
?
 
Last edited by a moderator:
I don't know the correct answer, but I think that they probably would look awesome with both sides detailed. That is just my opinion though.
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top