dome casting

Are you making a helmet from scatch? You can try using a baseball hemet. I've seen people just cut out the dome. Hope that helps.
 
if you can get your hands on some foam, preferably rigid foam you can carve it into a pretty good dome, that the way i did it. Then you can bondo over it, using a bondo file at first really helps, then sand it with 100 then 300 grit sand paper

IMGP0967.jpg

IMGP0975.jpg

IMGP1077.jpg

IMGP1107.jpg
 
that pink foam dome is an amazing idea, i was sort of thinking about doing that but of course i ended up with "there's no way that'll work"
Thank you for proving me wrong :lol:

:cheers
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top