Thorssoli Helmet ready painted!

looks great, brother! my son wanted a custom one, so he painted his himself...:lol: i told him he will want a real boba one, and yep, he does, so we'll be painting his the Boba way...:D
 
Thanks brothers! Yes, my little son is very proud and he always wants to touch the helmet and run around with it.

With installed visor the helmet is almost too small ... he crushes his nose if he wears the helmet ... and it is very tight on the head ... not easy for a small boy to go through this torture ... :)

I have to try to get more room inside it by sanding it out somehow ...

anyone an idea how to get rid of some material from the whole inside?

Cheers and thanks again for the nice feedback bros!

Manuel
 
Last edited by a moderator:
For my nephew's helmet I used an angle grinder with a flapwheel to dig out a little bit of the material on the inside. If you go that route, be careful. It would be very easy to grind a hole through the resin.
 
Thanks for the tip Shawn! I´ll go and have a look to get an angle grinder and a flapwheel.
I´ll keep posting any progress if I got it.
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top