Westar interest thread

TLobe00

Active Hunter
I know these have been done before... But I have a local machinist I have talked to about machining metal westars... He said they would be no problem and quoted me at about $350 a pair... I just wanted to see if there was any interest before I pursue for multiple ones (although I will probably still get some for myself regardless)

thanks,
Tony
 
well, I'm in if it can be done. I only act this way because we've seen these threads before. Good luck with it and if it happens I'd love to have a set.
 
i'd be interested. will they have the brass center tube as well? i'd love to see pics of the prototype
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top