Starting my first Mando today

Good good!!! as long as it's not normal paper, you should be fine!

Keep the updates coming!!!

:cheers
A'den


Alright :D

Right now im not feeling overly confident to apply the bondo-glass :wacko

I was hoping that someone could post a few pics or show me a link to a thread that does show steps on doing so :D

That would be greatly appreaciated :cheers thanks :D
 
hahaha!!! I'll have em up in just a few...I'll run out to the garage right now and get started...:D

Yeah, for 13 and 15 ya'll are well on the way to becoming amazing armourers! Way to start young and get a good start on it! :cheers
 
The drying time or the entire helmet bondoing process?

Drying time: depends on the amount of hardener: I can get it to dry anywhere from 2 to 10 minutes

Whole process: I dont know...takes a while...but if you do nice, even coats now, while that may take longer than just globbing it on, it save far more time later when you have to sand.
 
Ok i just spent an hour applying it (its dark now and im not completely down so i will finish tomorrow :D)

Just a few things i would like to point out
one, its really hard to apply it because the paper is so bendy (duh!) :lol:
two, im almost out of the hardning paste so i dont know what to do there
and three, IT SMELLS TERRIBLE :lol:

just felt like saying those three things :lol:
 
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top