Interest in Ali Shin Tool Parts?

Mojo Fett

Well-Known Hunter
Hi guys,

Me again... :rolleyes
I was wandering if anyone would be interested in some of the knurled parts found on the (Anti-security blade) shin tool?
These will be drawn in CAD and scaled to the Patterson squeegee I have for size ref altho I am prepared to take 'any' advice to enable these to be as accurate to detail as the gaunt darts I made... should anyone have any better ref :)

Shin Tools Post.jpg
 
Last edited by a moderator:
I only have ref for ESB but... you never know 'who' has some decent ref material? I am happy to make both. (y)
Price? dunno yet Scott, I'd like these to go out so that all can afford the upgrade?
 
Cheers guys.. I've just had a PM from another member who is also planning a run. So unless his does not come off then I'm gonna have to put this on hold unlike some others I won't step on toes. (y)
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top