rivoter

Chucko

Active Hunter
I'm scratch making clone armor out of storage container lids for my son and i want to rivot some parts together. What type of rivoter should I look for and where? Keep some what of a budget in mind.
 
You can usually pick up a basic pop rivoter at any hardware store, I work at a Home Hardware and bought mine there for about $20 canadian I think.
 
Or you could barrow mine and I think I still have some rivets too!! I used a while back when I did my TK armor.
 
Thanks for all the info.
I just went ahead and bought one from Lowes $24 with some rivets but I kept the receipt. So I might take you up on that offer Rob.
 
or, you could just hold the rivet in a vice, put the materials on the rivet and hit it with a hammer. thats what im useing for my mandalorian helmet
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top