Are there any templates for ESB scope mounts?

clonecollector

Well-Known Hunter
I've searched on here and could not find templates for the ESB scope mounts. (the two rings/ clamps) that the scope gets mounted to. Does anyone have any? Or does anyone have measurements? I know some guys were debating the shape of them in another thread. If I could scratchbuild my own I would use some of those ideas but I really need approximate sizes for the rings. Thanks alot for any help guys!

Paul
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top