Correct Back armor shaping

ZacicVolkshed

Jr Hunter
Ive took a look around the internet and Ive tried a few searches here and I cant find a good example of the shape of the back plate for the armor. I have the templates and have cut them out of sintra, shaped to the best degree I can but I still think Im missing the overall shape of the piece. I was just wondering if anyone had a few good pics of it.
 
Back-Bits.jpg
 
i've been realy having trouble forming the back plate to.Doing mine in 1/8th inch(3mm) thick aliuminium.
In the end i've decided to make a cast of my back to work from as it's far to difficult to see if its ok and hold it in place at the same time.
 
thanks for the pic spawnfreak, it helped me get the shoulders into the right place. If anyone has a side picture, showing the arch of the plate, it would be much appreciated
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top