Blaster help

sithstalker

New Hunter
Hey gang,
I resently picked up a foam Fett ROTJ blaster from a seller & was wondering what to use to make it more ridged?

It has ridged support inside but I want something to make the outside harder. Bondo or spray resin?

Any help would be apreciated.
 
they make a bedliner spray that could stiffin it up. its $10 bucks on ebay.

1f79_1_sbl.JPG
 
If it's flexible there's not too much you could do that wouldn't crack eventually. I think any kind of coating you add would begin to split after time if applied over a flexible material.
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top